13
6.2 Removing the battery
▶
Remove the battery.
6.3 Fitting the side handle
▶
Screw the side handle into one of the threaded bushings provided.
6.4 Fitting or removing the guard
CAUTION
Risk of injury.
The accessory tool may be hot or have sharp edges.
▶
Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and
when troubleshooting.
▶
Observe the instructions for fitting the applicable guard.
6.4.1 Fitting the guard
Note
The guard is equipped with locating lugs that ensure only guards of a type suitable for use with the
power tool can be fitted. The locating lugs of the guard fit into the guard mount on the power tool.
1. Fit the guard onto the drive spindle collar so that the two triangular marks on the guard and on the power
tool are in alignment.
2. Press the guard onto the drive spindle collar.
3. Press the guard release button.
4. Rotate the guard until it engages and the guard release button jumps back into its original position.
Printed: 26.01.2017 | Doc-Nr: PUB / 5292879 / 000 / 00
Printed: 26.01.2017 | Doc-Nr: PUB / 5292879 / 000 / 01
Summary of Contents for AG 500-A22
Page 2: ...Printed 26 01 2017 Doc Nr PUB 5292879 000 00 Printed 26 01 2017 Doc Nr PUB 5292879 000 01 ...
Page 8: ...6 Printed 26 01 2017 Doc Nr PUB 5292879 000 00 Printed 26 01 2017 Doc Nr PUB 5292879 000 01 ...
Page 9: ...7 Printed 26 01 2017 Doc Nr PUB 5292879 000 00 Printed 26 01 2017 Doc Nr PUB 5292879 000 01 ...
Page 23: ...Printed 26 01 2017 Doc Nr PUB 5292879 000 00 Printed 26 01 2017 Doc Nr PUB 5292879 000 01 ...