Configuration
30/146
8.2.2
Setting parameters
In the configuration software of the PROFINET IO-Controller you can set
the parameters for the device netFIELD IO-Link Wireless Master
PROFINET IO-Device NFD-3090-PNS-IOLM\W. The existing parameters
contain the basic settings for the device, which you adapt for your
application. Set the device and port parameters in the start-up parameters
of the configuration software of the PROFINET IO-Controller. The
PROFINET IO-Controller sends these parameters to the NFD-3090-PNS-
IOLM\W device when starting the communication.
Depending of the selected GSDML file (PDCT or Expert), the parameter
descriptions PDCT or Expert are valid for the submodules:
·
IO-Link Wireless Device X I / X O + PQI (PDCT, Expert)
·
IO-Link Wireless Device X I + PQI (PDCT, Expert)
·
IO-Link Wireless Device X O + PQI (PDCT, Expert)
X = 1, 2, 4, 8, 16, 32
In the configuration, one submodule is configured for each used wireless
IO-Link port WP.
PDCT
Parameter group
Parameter
Default Value range
Description
Wireless IO-Link port
parameter
(for WP01/WP02/ …)
Enable port diagnosis
1
0: Disable
The PROFINET port diagnosis is
deactivated, i.e. no diagnostic alarms
are triggered.
1: Enable
The PROFINET port diagnosis is
activated.
Enable process alarm
(device notification)
1
0: Disable
PROFINET process alarms are
deactivated.
1: Enable
PROFINET process alarms are
activated.
Enable input fraction
0
0: Disable
Input fraction is deactivated.
1: Enable
Input fraction is activated.
Enable pull/plug
1
0: Disable
PROFINET Pull/Plug alarms are
deactivated.
1: Enable
PROFINET Pull/Plug alarms are
activated.
Table 14: Parameters of the submodules IO-Link Wireless Device XX I / XX O + PQI (PDCT)
NFD-3090-PNS-IOLM\W | Hardware, installation and commissioning
DOC201101UM03EN | Revision 3 | English | 2022-02 | Released | Public
© Hilscher 2020 - 2022
