22
parameters of the terminal session to 115200bps, 8 data bits, 1 stop bit, none parity, and none
flow control, as shown in the figure below:
3.
Switch on the power supply, and the device performs self-test and initializes the
configuration automatically. If the booting succeeds, the system will display the command
line prompt "login". Enter the default administrator name and password "hillstone" at the
"login" and "password" prompts, press Enter. And now you are successfully logged in and
accessing the CLI. After login, please change the default password of the device in time.
4.
Enter commands to configure or view running status. Enter a question mark "?" to get
help on commands whenever you want.
WebUI
The MGT port has a default IP address of 192.168.1.1/24, and all the management functions of this
port are enabled by default. Administrators can access the WebUI through the MGT port.
To log in the device's WebUI, take the following steps:
1.
Set up the IP address of the management PC on the same subnet as 192.168.1.1/24.
Connect the management PC to the MGT interface through an Ethernet cable.
If the device has a MGT0 interface, connect the cable to this interface.
If the device does not have a MGT0 interface, connect the cable to the e0/0
interface.
Summary of Contents for A200 Series
Page 1: ...Hillstone A200 Series Hardware Reference Guide...
Page 5: ...5 EU Conformity Statement 27...
Page 20: ......
