Hillstone A200 Series, Hardware Reference Manual

Page: 16 / 27

16
Installation Devices/Tools/Cables
The SG-6000A-Series device is shipped with a power cable and a console cable, and you should have
the following items before the installation:
 Terminal: Configuration terminal (e.g. an ordinary PC).
 Tools: Cross screwdriver and ESD wrist strap/antistatic gloves.
 Cables: Power cable, console cable and Ethernet cable.
Chapter 3 Installation
A yellow seal with dark ink characters is stuck on a mounting screw of the chassis. Keep the seal intact.
The sales representative will check this seal before maintenance operation. Please get the permission of
your sales representative before opening the chassis yourself. Warranty will be void if you disassemble
the chassis without authorization.
Before installation, make sure that:
 The requirements in Chapter 2 Installation Preparations are satisfied.
The A200-Series device can be installed:
 On a workbench
Installing the Device on a Workbench
The A200-Series device can be placed on a stable and clean workbench. For skid prevention, take the
following steps to fit anti-skid pads on your device before installing:
 Step 1: Tear off the sticker from the rubber pad.
 Step 2: Press the sticky side of the pad to the right-angle die-pressed mark on the
bottom panel of the chassis.
Figure: Installing the Rubber Pads