HIKVISION UD01394B, User Manual

Page: 66 / 220

Digital Video Recorder User Manual
65
5.1 Configuring Encoding Parameters
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
Figure 5. 1 HDD- General
2. Click Advanced tab to check the storage mode of the HDD. (Menu>HDD>Advanced)
1) If the HDD mode is Quota , please set the maximum record capacity. For detailed information, see
Chapter 13.4 Configuring Quota Mode .
2) If the HDD mode is Group , you should set the HDD group. For detailed information, see Chapter 5.9
Configuring HDD .
Figure 5. 2 HDD- Advanced
Steps :
1. Enter the Record Parameters interface to configure the encoding parameters.
Menu>Record>Parameters
Figure 5. 3 Record Parameters
2. Set the parameters for recording.
1)
Select the Record tab to configure.
2) Select a camera from the camera dropdown list.
3) Configure the following parameters for the Main Stream (Continuous) and the Main Stream (Event) :
Stream Type : Set the stream type to be Video or Video & Audio.
Resolution: Set recording resolution.

The DS-7100HQHI-F/N, DS-7200HQHI-F/N, DS-7300HQHI-F/N and DS-8100HQHI-F/N series
support up to 1080p lite (960 × 1080) resultion. The DS-7200HUHI-F/N series support up to 3MP
resolution.

For DS-7200HUHI-F/N series, the default TVI/CVBS signal input type also supports the auto