Network Security Control Panel User Manual
54
Q: Why there is no Disarming Report?
A: To make sure the user has permission of Disarming Report, please refer to Operator
Configuration.
Q: What to do if the user cannot disarm after arming the system?
A: There are two different situations:
1.
The user does not have permission to disarm, please contact the administrator.
2.
Take the follow instructions when there is only one user in the system without
permission to disarm;
1)
Initialize the hardware, restore the password of operator, main operator password
and permission, and then disarm with main operator. The initialization password of
operator is: 012345, the initialization password of main operator is: 1234, the
permission is: arm/disarm. There is arm/disarm report and bypass is permitted.
Please refer to FAQ of hardware initialization for more information about hardware
initialization.
2)
The command code to restore factory parameters: {Password of operator} + {*} + {8}
+ {9} + {#}.
This method is not recommended because it will initialize all programming
contents.
Q: How to do the hardware initialization?
A: Control panel hardware initialization only initializes operator password: 012345 and main
operator password: 1234, main operator permission is arm/disarm. There are
arming/disarming report and allows bypass.
Steps:
1)
Power off the control panel and open the cover;
2)
Short the restore switch of the control panel with shorting nut or connection
cables;
3)
Power on the control panel and power off it 10s later;
4)
Please remove the shorting nut or connection cable on the restore switch;
5)
Cover the control panel well;
6)
Recharge the control panel;
Q: Why is there no response for keypad operational order but alert sound of error 10s
later?
A: It may be caused by follow situations:
1)
Poor contact of the connection cable between LED keypad and the control panel,
please check if the cable is normal;
2)
The LED keypad is considered as off-line in the communication. If there is other
keypad operates normal, process program command {Main Operator Password} +
{*} + {6} + {8} + {#}to restore it or power off the control panel and reboot.
Q: How does the control panel detect alternating current, storage battery, control panel
tamper-proof and ADSL cable?
A: The status of the control panel detection is as follows:
Summary of Contents for DS-PK00 series
Page 63: ......