HIKVISION DS-19A08-F/Kx, User Manual, Page: 138 / 157

Control Panel User Manual
138
For example: Valid Password: 1239, Duress Code: 1230 and 1238.
3. Please take the following notes while using duress code:
While using duress code, it is needed to enable duress report firstly, as to
program the control panel age report and delay. The programming command
to enable
Control Panel Hijack Report is as follow:
Command Address { 4 }{ 6} { 4 }
Enter Delay { 3 }
Exit Delay { 6 }
Siren Working Duration { 2 }
Control Panel Hijack Report {1}
End { # }
Q: How to solve the problem of two LED keypad address being same?
A:
When two LED keypad addresses are the same, the situation of two keypads
demanding bus communication at the same time will appear and cause
conflict. The only solution is to remove one keypad and reset the other
keypad to an unused legal address. Restore the control panel by processing
program code ({Main Operator}{*}{6}{8}{#})
Q: Why there is no Disarming Report?
A:
To make sure the user has permission of Disarming Report, please refer to
Operator Configuration.
Q: What to do if the user cannot disarm after arming the system?
A:
There are two different situations:
1. The user does not have permission to disarm, please contact the
administrator.
2. Take the follow instructions when there is only one user in the system without
permission to disarm;
1)
Initialize the hardware, restore the password of operator, main operator
password and permission, and then disarm with main operator. The
initialization password of operator is: 012345, the initialization password of
main operator is: 1234, the permission is: arm/disarm. There is
arm/disarm report and bypass is permitted. Please refer to FAQ of
hardware initialization for more information about hardware initialization.
2) The command code to restore factory parameters: {Password of operator}