HIKVISION 5 Inch Network High Speed Dome, Installation Manual

Page: 16 / 53

5 Inch Speed Dome Installation Manual V2.0.0
15
1.4 DIP Switch Settings
1.4.1 DIP Switch Settings for High Speed Dome and Auto Tracking High
Speed Dome
1 2
3
4
1. Address DIP Switch 2. Protocol DIP Switch
3. Wiring Connector 4. Address and Protocol Settings
Figure 1.4.1 Bottom Board of Dome Drive
The dome provides two DIP switches
SW1
and
SW2
for setting the dome address, baud rate, protocol, etc. As shown in Figure 1.4.1,
ON=1, OFF=0. In SW1 and SW2, 1 is the lowest position and 8 is the highest position. Please refer to the following list for specific
settings:
Note:
As the high speed dome is capable of being self-adaptive to PELCO-D, PELCO-P, PRIVATE-Code, VICON and KALATEL-32
protocols, and the network speed dome is self-adaptive to Pelco-P, Pelco-D and PRIVATE-Code protocols as well, no DIP switch
settings for control protocol are required.