20
English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom
Possible cause
Remedy
Tool doesn’t run
No remaining battery power
Charge the battery.
Battery isn’t fully installed.
Push the battery in until you hear a click.
Tool suddenly stopped
Tool was overburdened
Get rid of the problem causing the
overburden.
Overload protection is in operation.
The battery is overheated.
Let the battery cool down.
Cannot be inclined
The incline lever (front) and incline wing nut
(rear) are not loosened.
Try inclining after loosening the incline
lever (front) and incline wing nut (rear).
Tighten the loosened parts after making the
necessary adjustments.
Cannot reverse incline
The cutting depth is set at maximum.
Reverse incline after adjusting the cutting
depth to a lesser setting.
The incline lever (front) and incline wing nut
(rear) are not loosened.
Try inclining after loosening the incline lever
(front) and incline wing nut (rear).
Parallelism cannot be
fi
ne
tuned
The M5 hexagon socket set screw holding
the gear cover hinge needs to be loosened.
Loosen the M5 hexagon socket set screw
holding the gear cover hinge.
Doesn’t cut well
The saw blade is worn or missing teeth.
Replace with a new saw blade.
The bolt is loose.
Firmly tighten the bolt.
The saw blade is installed backwards.
Install the saw blade in the proper direction.
Switch can’t be pulled
The switch lock is not pushed in enough.
Push the switch lock in all the way.
Sawdust discharge is poor
Sawdust has accumulated in the saw cover. Remove the sawdust inside the saw cover.
Battery cannot be installed Attempting to install a battery other than that
speci
fi
ed for the tool.
Please install a multi volt type battery.
00Book̲C3605DA̲Asia.indb 20
00Book̲C3605DA̲Asia.indb 20
2018/12/21 14:39:16
2018/12/21 14:39:16
