PREDATOR XS TURNTABLE STRETCH WRAPPER OPERATION MANUAL
HIGHLIGHT INDUSTRIES, INC. ● 2694 PRAIRIE SW; WYOMING; MI 49519 ● 1-800-531-2465
III-4
MACHINE OPERATION
MACHINE OPERATION
MACHINE OPERATION
MACHINE OPERATION
Normal System Start-Up
After the machine has been positioned and supplied with proper voltage, you are ready to begin
operation. Read thoroughly and follow these steps to operate your system:
1. Place product on the turntable
2. Make sure the turntable is at home position.
3. Make sure the film carriage is situated at the max down position.
4. Thread the film as instructed, and attach it to the product.
5. Set the desired numbers for top and bottom wrap counts.
6. Select the “Up Only” or “Up/Down” wrapping mode.
7. Turn the “Turntable” and “Film Carriage” selector switches to Auto position.
8. Press the “Start” button to initiate cycle.
Stop Condition
Follow procedure below in the event of emergency.
1. Press the “STOP” button. This cancels the current wrapping cycle and immediately stops
the system.
2. Correct the problem.
3. Pull the “STOP” button out, and then perform normal system start-up procedure.
NOTE
After pressing the “E-STOP” button, wait for at least 60 (sixty) seconds
before pulling the button back out. This will allow the frequency drives
to completely go off.
