PREDATOR XS TURNTABLE STRETCH WRAPPER OPERATION MANUAL
HIGHLIGHT INDUSTRIES, INC. ● 2694 PRAIRIE SW; WYOMING; MI 49519 ● 1-800-531-2465
II-2
MACHINE SET
MACHINE SET
MACHINE SET
MACHINE SET-
-
-
-UP
UP
UP
UP
It is very important to read all instructions before undertaking any of these steps. The following
steps should help achieving a safe and quick machine set-up.
1. Place skidded machine close to the designated wrap area. Remove all shipping fasteners
holding the machine to the pallet. The machine may be crated with the tower tilted down
with the motor cover front carriage roller removed for shipping purpose.
2. Place forks of the forklift through the tubes provided at the rear base of the module, remove
the machine from these skids, and place it at the designated wrap area.
3. If the OPTIONAL ramp (Part Number #600086) is purchased:
Select a ramp position as illustrated below. The ramp can be positioned anywhere in a 180°
rotation around the front of the turntable. There should be a ¼” gap between the turntable
and the ramp. The ramp should be fully supported by the floor. Both the ramp and the
machine should be lagged to the floor.
Exhibit 2-1: Ramp Positioning for Predator XS Low Profile
WARNING
It is very important that the system be leveled.
Uneven floor will cause premature turntable support roller failure.
