Highland HP4IFC-2, Use And Care Manual

Page: 9 / 20

9
Residual heat indication
After the heating zone is turned off, or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
When the re
sidual heat indicators are on, don’t touch the heating zones and don’t put any heat
sensitive object on them. There are risks of burn and fire.
Booster function
The Booster function [ P ] and the Double Booster [ ] grants a boost of power to the selected
heating zone.
If this function is activated the heating zones work for 10 minutes with an ultra high power.
Booster is needed for example to heat up large quantities of water rapidly, like for noodles

Start up / Stop the booster function:
Action Control panel Display
Start up the Booster s
lide to the end of the “SLIDER”
[ P ]
or press directly on the end of
the “SLIDER”
Stop the Booster s
lide on the “SLIDER“
[ 9 ] to [ 0 ]

Start up / Stop the double booster function:
Action Control panel Display
Start up the Booster s
lide to the end of the “SLIDER”
[ P ]
or press directly on the end of
the “SLIDER”
Start up Double Booster re-press key [ P ] [ and P ]
Stop the Double Booster s
lide on the “SLIDER“
[ P ] to [ 0 ]
Stop Booster s
lide on the “SLIDER“
[ 9 ] to [ 0 ]

Power management:
The whole cooking hob is activated with a maximum limit of power. When the booster function is
activated, and in order to exceed the maximum power, the electronic system reduces the power
level of other heating zones. The display will blink on [ 9 ] for a few seconds and then shows the
maximum of power allowed :
Heating zone selected The other heating zone: (example: power level 9)
[ P ] is displayed [ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Timer
The timer is able to be used simultaneously with all heating zones with different time settings
(from 0 to 999 minutes) for each heating zone.

Setting and modification of the cooking time :
Action Control panel Display
Select the power level
slide on the “SLIDER“
[ 1 ] to [ P ]
Select the Timer press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Decrease the time press key [ - ] from the timer [ 60 ] to 59, 58...
Increase the time press key [ + ] from the timer Time increase
After a few seconds, the [ min ] display stops with blinking.
The time is confirmed and the timer starts.