High Lifter PGL-KIT-RZRT, Manual, Page: 18 / 34

PGL-KIT-RZRT 18
c. If the camber is (-) you will need to add a shim. If the camber is (+) you will need to remove a shim. You are
provided a 1/8” shim and a 1/16” shim for each portal to better achieve the correct angle. You can remove
or use both of them as needed.
d. To add or remove shims, you will need to completely disconnect the upper ball joint mount bracket from
the portal box. You can leave the portal box attached to the lower ball joint and leave the mount bracket
attached to the upper ball joint while you change shims in the next step.
e.
Now that the backing plate is accessible, remove or add shims as needed.
f.
Reconnect the upper ball joint mount bracket to the portal box. Check the camber again. If it’s correct,
proceed to step #7. If not, repeat the previous step until you achieve the correct angle.
NOTE: You can purchase more shims if needed