High Lifter PGL-KIT-RZRT, Manual, Page: 12 / 34

PGL-KIT-RZRT 12
4. FRONT PORTAL BOX ASSEMBLY
a. Remove the (4) 8- 32x1/2” screws & (1) cap and gasket from the lid of the portal box PGLC-BOX430-R-P.
b.
The box comes pre-installed with a ½ x 1 ½” bolt and 1/2” lock washer in the upper caliper mount hole. You
will not re-use this lock washer for the front boxes. Just insert the ½ x 1 ½” bolt through the upper hole of
the caliper mounting bracket PGLC-BCB-85Y and place it in the corresponding fitted section of the front
portal box and fasten it tight. (3/4) [90 ft lbs]
c.
Slide (1) 1/2” flat washer onto (3) ½ x 4 ½” bolts. Insert these bolts through the three holes shown below.
Then insert (1) ½ x 4 ½” bolt into the lower caliper mount hole. This bolt does not use a washer for the
front portal boxes.