Box spring Hilo
TECHNICAL MANUAL
page 50 of 62
3.
Disconnect the mains cable from the control box. To do this, you have to push in two red pins,
while pulling the plug out of the control box. A flat screwdriver is the best tool to push in these red
pins. To install the mains cable, you have to push in both pins while you plug in to the control box.
Make sure that both pins are anchored properly in the control box. You can check this by pulling
the plug.
Figure 9.6: Replacement of the mains cable in the control box
4.
Install the strain relief again. Make sure that the strain relief is fixed properly and not damaged.
The strain relief has an extremely important function: it avoids traction on the control box in case
the mains cable is used incorrectly.
Figure 9.7: Fastening of the strain relief
9.9 Replacement of a control box
Disconnect the control box CO61 from the net. Unplug the control box. Remove the control box from
its support plate. Install a new control box and connect all plugs again (see circuit diagram, figure 6.1).
Figure 9.8: How to replace the control box
Summary of Contents for Hilo
Page 2: ...Box spring Hilo OPERATING INSTRUCTIONS page 2 of 62 ACTIVATION SUMMARY...
Page 3: ...Box spring Hilo OPERATING INSTRUCTIONS page 3 of 62 ASSEMBLY SUMMARY...
Page 34: ...Box spring Hilo TECHNICAL MANUAL page 34 of 62 TECHNICAL MANUAL...
Page 61: ...Box spring Hilo APPENDIX page 61 of 62 APPENDIX 3 TRAINING CERTIFICATE...
