Hidden Hilo, Operating Instructions Manual

Page: 45 / 62

Box spring Hilo TECHNICAL MANUAL
page 45 of 62
▪
cable clamp: All cables are fastened by means of clamps that can be removed and locked
without needing any tools.
Figure 9.2: Cable clamp
9.4 Replacement of a high/low actuator
1. Put the bed in a position, as high as possible.
2. Support the mattress platform at the head and foot end so that it cannot fall.
3. Disconnect the actuator cable from the actuator. It is advisable to check if the actuator you have to
replace is really damaged. This is possible by plugging a new actuator in the control box without
actually building it in, and checking its functions.
4. First remove the axle at the side of the carriage. Do not forget to support the actuator so that it
cannot swivel downwards. After this, the second axle near the suspension point can be removed,
making it possible to remove the actuator from the bed.
The opposite working method has to be followed to install an actuator in the bed.
9.5 Replacement of a mattress platform actuator
1. Disconnect the bed from the net.
2. Remove the load (e.g. mattress) from the mattress platform that exerts pressure on the actuator.
3. Disconnect the actuator from the control box. It is advisable to check whether the actuator is really
damaged. This is possible by plugging a new actuator in the control box without actually building it
in, and checking its functions.
4. Open all cable clamps and remove the axle retaining ring from both axles.
5. First remove the axle on the side of the moving mattress platform section, but make sure that the
moving mattress platform section and/or the actuator cannot come loose and/or fall. Afterwards,
the second axle can also be removed, making it possible to take the actuator out of the bed.
The opposite working method has to be followed to install an actuator into the bed.