User manual - Machine Automation Solution - V3R003
61 / 102
Realign the guide by moving the GNSS position
The GNSS system is subject to information variation. It is recommended to use the
Realign GNSS
function if, after
pausing the operation for a while, the guide does not show the same location as before when you start over again. This
function transfers the GNSS position guide automatically until the point where the antenna/vehicle is, aligning it with the
guide (zero error).
To perform a realignment GNSS adjustment, proceed as follows:
1.
With the guide active, click on icon
Realign (with GNSS image)
;
2.
The guide is adjusted according to the vehicleʼs antenna position.
Figure - Realign GNSS
Important
In this option, as the positions of the guides are changed, it is not possible to return the
position of the original guide. If you intend to work again in the area already applied using the
same guides, it is advisable to use the other behavior that would be to realign by creating a
new guide.
Realign the guide by creating a new guide
A new original guide similar to the previous one is drawn in the same location where the vehicle / antenna is located and
new parallels will be drawn. The previous original guide can be accessed again in the guide manager, if it has been saved.
To perform a realignment guide adjustment, proceed as follows:
1.
With the guide active, click on icon
Realign (with guide image)
;
2.
2. A new guide appears at the vehicle's antenna position.
Figure - Realign guide position
Important
In this option, the visual result for the user is the same as the previous option, the movement
of the guide aligned with the vehicle, but here in fact a new guide was created and using the
previous original guide it is possible to repeat the work in the field.
11.2.2.2 Manual adjustment
