Hewlett Packard Enterprise ProLiant DL20 Gen10, Maintenance And Service Manual

Page: 47 / 153

a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Remove the access panel.
7. Remove the M.2 air guider.
To replace the component, reverse the removal procedures.
Removing and replacing the quick-release latch ear
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Remove the inner left rail attached to the chassis.
7. Remove the quick-release latch ear:
Removal and replacement procedures
47