68/97
6.18 Delete programs and program linking
The deletion of programs and program linking is only possible if the rotor is at
standstill.
The deletion of individual programs or program linking is not possible. Always
all programs or program linking are set back to default values.
It is at any time possible to terminate the procedure by pressing the
STOP / OPEN
key.
Action
Display / Comment
1. Keep the
START
key
and the
STOP / OPEN
key pressed and
switch on the mains
switch at the same
time.
→
∗∗∗
Select Menu
∗∗∗
2. Press the
PROG
key
so often until the
following will be
displayed:
→
-
>
Eeprom
3. Press the
START
key.
→
Eeprom Read
4. Press the
PROG
key
so often until the
following will be
displayed:
→
Erase Single Progs no
or
Erase Multi Progs no
Single Progs = Programs.
Multi Progs = Program linking.
It is possible to jump back to the previous display
by pressing the
T/°C
key.
•
Turn the control
knob one step to
the right.
→
Erase Single Progs yes
or
Erase Multi Progs yes
no = Do not delete programs or program linking.
Yes = Delete programs or program linking.
5. Press the
START
key.
→
Are you sure ? no
Repeated confirmation.
•
Turn the control
knob one step to
the right.
→
Are you sure ? yes
no = Do not delete Programs or program linking.
Yes = Delete Programs or program linking.
6. Press the
START
key.
→
-
>
Eeprom
Summary of Contents for ROTINA 420
