gloves to avoid being burned by hot surface of components or
molten glue.
9) Do not use any tool that is with flaming or a sharp tip to clean
melting tank to avoid damaging the Teflon coating on surface of
tank.
10) Please stop operating roller coater immediately when the hot
melt glue is leaking out. And inform the qualified people to
maintain.
1-6 SAFETY WHEN USING HOT MELT ADHESIVE AND SOLVENT
A. HOT MELT ADHESIVE
1) The surface of hot melt adhesive would be solidified immediately
at normal temperature. However, molten adhesive inside is still
high temperature.
2) Always wear protective glasses, clothing and heat-resistant
gloves when load hot melt adhesive into tank or operate machine
close by.
B. SOLVENT
1) Do not use an open flame or uncontrolled heating devices to heat
solvents.
2) Do not use solvent that has high volatility to avoid burning and
exploding at high temperature. And this kind of solvent may result
poison air at high temperature.
3) Make sure the working area is ventilation enough before use
solvents.
4) Do not work under using cleaning solvent for a long time to avoid
breathing too much poison air that caused by high temperature.
NOTICE:
If skin is touched by molten hot melt adhesive,
1) Do not try to remove the molten adhesive on the skin.
2) Immerse the affected area into cold water until the adhesive is
cooled down.
3) Do not try to remove the cooing adhesive from the skin.
Summary of Contents for HS7003B
