HES HS7003B, User Manual

Page: 14 / 31

NOTE:
Please disconnect the external power supply before loading HMA
into tank. Otherwise there is still some voltage at wire head.
2) Turn on the external power supply.
3) Turn on the main switch on control panel, and refer to 4-3 to make
setting on PID temperature controller.
4) Prepare some materials, like leather, cloth, etc. for trial
coating.
5) Start motor after temperature reaching setting value, and make
sure HMA inside tank being melted completely.
4-5 NORMAL OPERATION PROCEDURES
4-5-1 PROCEDURE OF TURNING ON MACHINE
1) Turn on the external power supply.
2) Turn on the main power switch on control panel.
3) Check HMA inside tank is at least 30
%
in tank. (80
%
full of tank
is suggested.)
FIGURE 4.3 CAPACITY OF MELTING TANK
4) Check the temperature on PID controller whether it is reaching
setting value. (SV=PV)
5) When setting value is reaching, checking HMA inside tank is melted
completely, and then the motor can be started.
4-5-2 PROCEDURE OF TURNING OFF MACHINE
1) Turn off main power switch on control panel.
2) Disconnect the external power supply.