Heraeus CRYOFUGE 6000i, Operating Instructions Manual

Page: 36 / 54

"SEPACONTROL" Programming
32
Additional setting information
Input in the curve field
The different curves for acceleration and deceleration are explained in more detail
in the chapter "Acceleration and deceleration curves".
The acceleration curves can be adjusted from 1 to 9.
The deceleration curves can be adjusted from 0 to 9.
(Acceleration and deceleration effect increases from 1 to 9)
Deceleration curve 0 means non-decelerated slow-down, that means the braking
curve is not defined.
Attention: If with the chosen curve 0 the set speed is reduced during the
operation, the new set speed is driven with deceleration curve 1; the previ-
ously chosen curve 0 remains unaffected.
Input in the four-function field
1. Speed
Input of the speed can take place in steps of 10, 100 or 1000 from 300 rpm up
to the maximum speed of the inserted bucket.
2. RZB
The RZB set value can be entered in steps of 1, 10, 100 or 1000 from the
equivalent of 300 rpm up to the maximum RZB value of the inserted bucket.
3. Rotor / bucket
Pre-setting the bucket is only possible before the start of centrifugation. The ro-
tor order numbers are saved in ascending order, and can only be entered as
integers.
CAUTION – DANGER!
The order number (last 4 digits) of the inserted bucket must always be
programmed, in order to avoid risk of accidents by possible errors in the
programming of speeds (see rotor table)!
4. Radius
Setting the radius is dependent on the bucket and can be carried out in steps of
1cm or 0.1 cm starting from the nominal radius (maximum value) until the small-
est possible radius. The maximum and minimum radii of the buckets relate to
the swung-out state during centrifuging.
accel
decel
select
9
accel
decel
select
8
speed
rcf
rotor
radius
select
5050
speed
rcf
rotor
radius
select
6000
speed
rcf
rotor
radius
select
6680
speed
rcf
rotor
radius
select
29.8