4
1 Please observe the following
1.2 Items Supplied
– 300 ml Cartridge Dispenser with hand lever valve and proximity switch "Empty",
Type 97631, Order No. 854181,
– Pushers for the use with Al, SEMCO, Ritter and Fischbach cartridges.
– Cartridge adapters for the use with Al, SEMCO, Ritter and Fischbach cartridges.
– Pneumatic hose OD 6 mm calibrated, ID 4 mm, length 2 m.
– Sleeve for Al cartridge.
– Silicone grease for pusher rod.
– Operating manual.
Further information to order the required units see sections 4.4, 4.5, 4.6 and 4.7.
1.3 Field of Application (Intended Usage)
The Cartridge Dispenser 97631 is used to dispense bubble minimized Loctite products
in 300 ml cartridges such as Gel-CA, Anaerobics, Epoxies and Silicones.
In connection with a dispensing valve or eccentric rotor pump it can be used in transfer
lines, manual or automatic work places.
1.4 For your Safety
Refer to the technical data sheet of the assigned adhesive under the address
www.loctite.com or request the technical data sheet and the safety data sheet (acc. to
the EC Directive 91/155/EC) for the LOCTITE
®
product used at
Henkel AG & Co. KGaA
+49 89 92 68 11 67 for English version of data sheets;
089-92 68 11 22 for German version of data sheets.
Follow unconditionally the INSTRUCTIONS of these data sheets!
While under warranty, the unit may be repaired only by an authorized Loctite service
representative.
Warning!
If chemical products are not properly handled, damage to health can result!
Observe general safety regulations for the handling of chemicals!
Observe manufacturer’s instructions!
Request a safety data sheet for the LOCTITE
®
-product used!
When working with pressurized air, wear protective glasses!
Removing, by-pass or putting out of operation of the safety devices can result in
damage to health and to the unit and is therefore prohibited!
