Data subject to change without notice. For more information visit our website: www.helvar.com
9
Notes:
• “Manual ON, Automatic OFF” feature = PIR will not switch the lights on when movement is
detected, but will switch them off if no movement is detected.
• Regardless of other light level commands (e.g. changes in the constant light level), an enabled
PIR will switch the lights to the PIR OFF scene if no movement is detected within its programmed
delay time.
Presence detector (PIR)
• Simultaneously press & hold “
3
” & “
4
” for 10 seconds.
• The operation is confirmed by flashing the lamps.
Note:
This also resets all scenes.
10 seconds
1
3
4
2
0/1
Disable “Manual ON, Automatic OFF” feature
(only possible through initial configuration / minisensor reset)
1
3
4
2
0/1
10 seconds
10 seconds
1
3
4
2
0/1
• Simultaneously press & hold “
0/1
” & “
2
” for 10 seconds.
• Simultaneously press & hold “
0/1
” & “
3
” for 10 seconds.
Note:
This must be done before setting the PIR delay time. If
you require a different delay time please see PIR delay
time settings instructions
.
Enable “Manual ON, Automatic OFF” feature with 20seconds delay time
1
3
4
2
0/1
10 seconds
1
3
4
2
0/1
10 seconds
• Simultaneously press & hold “
0/1
” & “
2
” for 10 seconds.
• Simultaneously press & hold “
0/1
” & “
4
” for 10 seconds.
Note:
This must be done before setting the PIR delay time. If
you require a different delay time please see PIR delay
time settings instructions.
Enable “Manual ON, Automatic OFF” feature with 20min. delay time
1
3
4
2
0/1
10 seconds
• Simultaneously press & hold “
0/1
” & “
2
” for 10 seconds.
• The operation is confirmed by flashing the lamps.
Disable PIR.
10 seconds
1
3
4
2
0/1
• Simultaneously press & hold “
3
” & “
4
” for 10 seconds.
• The operation is confirmed by flashing the lamps.
Note:
This also resets all scenes.
Enable PIR
(only possible through initial configuration / minisensor reset).
