6
Data subject to change without notice. For more information visit our website: www.helvar.com
Initial configuration / Minisensor reset (default settings)
Upon first application of power the Minisensor operates according to the programmed memory of the
EL-si ballast. If the ballast has no program then the IR buttons “ ” , “ ” and “
0/1
”(On/Off) will be
active. Channel control is also active. This allows the control of channels A&B (please see section “IR-
control” for more information). To program default scenes 1-4 and to activate further features, please
see the “Initial configuration” section for more information.
Use the Helvar Digidim infrared remote control for configuration.
Settings installed:
• IR address group. (See notes)
• Constant light sensor enabled.
• Constant light level must be programmed.(See “Constant light” section)
• Constant light level is measured and updated every 5 seconds
• PIR enabled.
• “No movement detected” delays:
• After 20 minutes switch to minimum light level.
• After an additional 20 seconds, switch lights off.
• IR receiver enabled.
• Last level recall function disabled.
• Basic lighting scenes stored.
• 100%
=
scene
1
• 75%
=
scene
2
• 50%
=
scene
3
• 25%
=
scene
4
• 100%
=
PIR
ON
light level scene
• 1%
=
PIR
LOW
Light Level scene
• 0%
=
PIR
OFF
light level scene
10 seconds
“Out-of-box” operation
Simultaneously press & hold “3” & “4” for 10 seconds to install initial settings.
(The operation is confirmed by flashing the lamps.)
1
3
4
2
0/1
Notes
:
• Set the rotary switch of the remote control (in battery compartment) to
an address group (0-F).
- All Minisensors will respond to Digidim remote controls set to
address 0 or D.
- If more than one remote control will be used to control different
Minisensors in the same area the remote controls must be
addressed to different groups (1-9, A, B, C, E or F). The Minisensor
will then respond to its corresponding remote control only.
• Always point the remote control directly at the Minisensor to be
configured.
- Take care that no other minisensor is in the IR-reception area unless
they are supposed to belong to the same address.
• Point at the minisensor to be addressed and press
“3” & “4”
for
10 seconds or until lights flash.
