Data subject to change without notice. For more information visit our website: www.helvar.com
15
Programming examples
Appendix B
Energy saving lighting with “Constant light” and “Automatic off manual on” features:
- Manual switch on only
- Lights will go off in 30 minutes when no movement is detected in the room.
- Lighting level will remain the same despite the changes in the natural light
1. Reset the minisensor (page 6)
Press and hold keys “
3
” & “
4
” simultaneously for 10 sec. (or until the lights flash.)
2. Change and store the constant light level (page 8)
i) Select the desired overal light level with “ ” , “ ” buttons
ii) Press key “0/1” for 10 seconds(or until the lights flash) to store the light level
3. Enable “Manual ON, Automatic OFF” feature (page 9)
i) Simultaneously press & hold “
0/1
” & “
2
” for 10 seconds.
ii) Simultaneously press & hold “
0/1
” & “
4
” for 10 seconds.
4.Change the PIR delay time to 30 minutes (page 11)
i) Simultaneously press & hold “
0/1
” & “
3
” for 10 seconds.
ii) Simultaneously press & hold “
0/1
” & “
4
” for 10 seconds.
iii) Simultaneously press & hold “
0/1
” & “
4
” for 10 seconds.
Energy saving lighting with “Presence detector” and “Constant light” features:
- Lights will go off in 20 minutes when no movement is detected in the room.
- Lights will go on if being off when movement is detected
- Lighting level will remain the same despite the changes in the natural light
1. Reset the minisensor (page 6)
Press and hold keys “
3
” & “
4
” simultaneously for 10 sec. (or until the lights flash.)
2. Change and store the constant light level (page 8)
i) Select the desired overal light level with “ ” , “ ” buttons
ii) Press key “0/1” for 10 seconds(or until the lights flash) to store the light level
10 seconds
10 seconds
