52
14) Remove the screw 19 as shown in figure 4-8-11. Remove the tilting cylinder
15.
15) Remove the screw 7 as shown in figure 4-8-11. Remove the limit plate 10
and side shifter front carrier 2.
Note: make sure the lifting equipment has the capacity of 905kg at least.
4.8.18.5 Change the axle sleeve (forward reaching assembly)
When removing the old axle sleeve, make sure the area near axle sleeve is well.
If there is any damage, remove all furs or coarse surface.
Apply a thin layer of lubrication grease on axle sleeve seat to make it is easy for
install and reduce the damage possibility.
Note: after assembling, check all axle sleeve standby and make sure wear surface
is well.
4.8.18.6 Repair and adjusting of center pix axle
Note: make sure the cleanness of all contacting surface and make sure there is no
furs or fragment that may damage the thrust washer.
When changing the washer 24 and 25 on two sides of scissor plate assembly as
shown in figure 4-8-10, apply a thin layer of grease on all surfaces.
Please tighten lock cover 23 on the pin axle 17 to lock position. Loose the screw
nut and then tighten it to a torque of 7.3Nm. Then loose it to the following position
nearest to the slotted pin.
4.8.18.7 Assembling of forward reaching mechanism
Before assembling, all parts hall be clean and make sure there is no furs or coarse
edge that may damage axle sleeve during assembling. Apply a thin layer of grease on
all axle sleeve, washer or pin axle.
The assembling steps are opposite from the disassembling steps.
Note: 1. If the scissor plate assembly 4 can not be installed into bracket 1 as shown in
figure 4-8-10, it means that there is deformation or curve of scissor plate assembly 3,
Summary of Contents for CQD16X1
Page 1: ......
Page 9: ...5 II External View of Reach Truck Figure 2 1 External view of reach truck ...
Page 102: ...98 6 3 Lubricating chart ...
Page 105: ......
