35
for other rollers in the listing system.
4.8.6 Adjustment of rear lifting cylinder
Readjusting the lifting cylinder travel distance according to the following method
after changing the lifting cylinder, inner mast, middle mast and outer mast.
Figure 4-8-3 Rear lifting cylinder installation instruction
(1) Install the plunger rod into the middle mast beam after adding adjusting shim into
the plunger rod head.
(2) Lift the mast slowly to the max. cylinder travel distance. Check if the two
cylinders are synchronized. If the two cylinders do not stop at the same time, that
means the two cylinders travel distances are different. Add shims between the plunger
rod head which is lower and the middle mast beam to ensure the synchronization of
two cylinders. The thickness of the adjusting shim is 0.5mm and 1mm.
4.8.7 Peeling
For new mast, peeling of mast surface is not rare. The phenomena is normal
because it means the roller runs on the steel channel. The phenomena will disappear at
last. The lubrication grease on the steel channel will stick these particles.
4.8.8 Disassembling of mast
4.8.8.1 When disassembling with unlimited space
Rear lifting cylinder
Middle mast beam
Adjusting shim
Summary of Contents for CQD16X1
Page 1: ......
Page 9: ...5 II External View of Reach Truck Figure 2 1 External view of reach truck ...
Page 102: ...98 6 3 Lubricating chart ...
Page 105: ......
