46
4) Lift the telescopic fork with lifting equipment to make it be higher than front
lifting cylinder. Support the bottom of telescopic fork with hard wood.
5) Disconnect the hydraulic pipelines and control cables to the cylinder.
6) Remove the cylinder limit bolt, see item 6 in figure 2.
7) Remove the cylinder fixing clamp, see item 7 in figure 2.
Place a container under the cylinder that is to be disassembled. Disconnect the
hydraulic pipelines from the bottom of cylinder. Block the cylinder and pipeline
connectors with plug to protect the hydraulic oil from pollution and to protect the
connectors from damage. Also it is good for oil draining.
Take care when disassemble and assemble hydraulic oil cylinder and ensure the
cleanness of cylinder. Before disassembling, clean dirt and grease on its surface. After
the cylinder is disassembled, clean all metal parts with solvent and then dry them with
compressed air. Check the plunger piston assembly and cylinder bore. If there is
scratch, slotting, pit or wear, change it.
4.8.17.4 Tilting cylinder
Figure 4-8-7 Diagram of side shifter assembly
Tilting cylinder is installed at the bottom of telescopic fork (item 15 in figure
4-8-7 is tilting cylinder). The tilting cylinder is a double-action piston type cylinder.
Be care when carrying out any repair. If there is abnormal leakage on the cylinder
Summary of Contents for CQD16X1
Page 1: ......
Page 9: ...5 II External View of Reach Truck Figure 2 1 External view of reach truck ...
Page 102: ...98 6 3 Lubricating chart ...
Page 105: ......