Installation instructions Art. No. 35266,35268
Page 2 of 2
Status 06.2014
Disposal:
Old electronic equipment must be brought to public connection points and must not be disposed of as
household waste.
Installation:
This product may only be installed by a qualified specialist electrician.
Make sure that the connection values for the power supply to your building installation agree with the
data on the rating plate for this light.
Before the installation is done, the connection lines must be switched free from voltage and protected
against being switch on again. Take the appropriate automatic circuit breakers out of the junction box in
the building.
The wall light is suitable for attachment to a normal flammable surfaces.
Do not install the light directly next to heat sources, gas lines, oil lines or open heat sources.
Protection of the wall light with a default current circuit breaker is recommended when it is being used in
an exterior area.
Decide on the location where installation has to take place. Make sure that no water can collect at the
place of installation.
Make sure that the base is suitable to support the weight of the light permanently and reliably. Hold the
light housing at the desired installation position and mark the drill holes. Use suitable screws for
fastening the light. Make sure that no lines are damaged.
Now connect the connection lines at building installation to the screw terminals of the light. Connect up
the yellow-green ground wire first of all and then the other two lines. The brown (or black) cable is
usually the phase conductor, connect this to the terminal marked with an "L". The blue conductor must
be connected to the terminal marked with an "N".
Do not bend the cable, make sure that the cable and the plug are free from strain and rotational forces.
Protect all the cables and insulations from possible damage.
Push the dowels into the drilled holes and fasten the housing by using suitable screws. Make sure you
have a stable and reliable fastening.
Switch on the circuit breakers of the junction box in the building again.
The rating plate must not be removed.
Heitronic
®
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
35266
35268
