1
Regulations
To ensure correct functionality and safety please read instructions
carefully before using this product. This luminaire complies with
AS/NZS 60598.2.1. All wiring and installation of this luminaire must
adhere to local and national wiring rules e.g. AS/NZS 3000:2007
Amendment 2:2012 Electrical Installation.
Tips
1. Always ensure power is off
and the fitting has cooled
down before performing any
maintenance or adjustment to
the fitting
2. To avoid injury or damage to
the fitting, ensure that power
leads and screws are secure
before connecting the power
3. Handle the fitting with care
to avoid breakage
4. Find a suitable location away
from liquids or hazards
5. To clean, wipe with a damp clean
cloth. Never soak the fitting
with water.
Note: Please check fitting label to
see if fitting is dimmable and if so
which type of dimming.
Warning
1. Switch off power before
installation
2. Switch on only after complete
installation and examination of
the circuit
3. Only a qualified electrician can
install and maintain this fitting
4. Product modification and/or
improper installation will
void warranty.
Surface Mounted Installation
Exterior
Batten
A. Mark 4 points with pencil on the surface of
ceiling/wall.
B. Drill 4 holes at the 4 marked points.
C. Insert one expansion stopper into each of the
4 holes.
D. Fix the 2 hooks into the ceiling/wall by 4 screws.
AB=CD, AC=BD
0.6m AC = 400mm
1.2m AC = 900mm
1.5m AC = 930mm
| Gr
ac
e Ext
erior B
att
en – In
st
all M
an
u
al
n
o
vii.c
o
.nz
IP65 IK10