Heiniger DELTA3, Instruction Manual

Page: 24 / 152

12 Instruction manual DELTA3
The air filter is blocked, and
the air can no longer circulate
(Fig. 12).
Clipping tension is too high.
Defective bearing
Have the brushes replaced by
the service centre.
Have the rotor and/or stator
replaced.
Have the electronic unit (PCB)
replaced.
Carbon brushes worn down.
Rotor or stator are defective.
Electronic unit (PCB) defective.
Have the electronic unit (PCB)
replaced.
Electronic unit (PCB) defective.
No power.
Faulty cable.
Faulty switch or motor.
Electronic unit (PCB) defective.
Check the lead and the fuse.
Have it checked and replaced
by the service centre.
Have it repaired by the service
centre.
Have the electronic unit (PCB)
replaced.
Motor does not run.
Motor runs very slowly.
Speed adjustment does not
work.
Motor section becomes warm.
Very loud whistling noise from
the motor section.
Motor vibrates.
MALFUNCTION RECTIFICATION CAUSE
Motor section
Have the rotor replaced.
Have the bearings replaced.
Rotor running untrue (caused
by a sharp blow).
Bearings are worn out.
Have the gears lubricated. No lubricant film on the gears
(Fig. 1, Item 9).
Remove the air filter and clean
with a brush, or replace the
filter.
Do not tighten the tension nut
so much (Fig. 6). If the blades
still do not cut they must be re-
sharpened or replaced.
Have the bearings replaced.