Heiniger DELTA3, Instruction Manual

Page: 23 / 152

Instruction manual DELTA3 11
Have the laminated springs
and/or socket head cap
screws replaced.
Thread is rusty or soiled.
Pressure spring jammed.
Have the cogwheel replaced. Cogwheel defective.
Laminated springs completely
broken.
Crank drive block and/or
crankshaft are worn out
(inadequate lubrication).
Have the laminated springs
replaced on both sides.
Have the crank drive block
replaced.
Have the crankshaft replaced.
Clipper blades are blunt.
Clipper blades have not been
correctly ground.
Clipper blades are not oiled.
Clipping tension too low.
Laminated springs broken.
The animal’s hair is wet.
Hairs jammed between the
upper and lower blades
(Fig. 5, Items 1+2).
Clipper head has too much
play.
Spacing between upper
and lower blades incorrectly
adjusted.
Animal clipper head
Insufficient movement of the
upper blade.
Tension nut jams.
Driving carrier has too much
play between the laminated
springs.
Driving carrier can only be
moved up and down with
difficulty.
Cuts badly or not at all.
No movement of the upper
blade.
Laminated springs have play in
the head anchorage.
MALFUNCTION
Have the thread cleaned and
oiled.
Have the pressure spring
replaced.
RECTIFICATION
Have the Comb screws
tightened.
Have a new centring bush
fitted.
CAUSE
Comb screws loose.
Laminated springs and/or
socket head cap screws are
worn out.
Centring bush lost.
Have the upper and lower
blades reground by the service
centre.
Oil the clipper blades every
15 minutes (Fig. 4).
Increase the pressure by
tightening the tension nut (Fig. 3)
Have the laminated springs
replaced.
Only clip when hair dry.
Disassemble the blades, clean
well and oil, and then refit and
increase the pressure.
Have the clipper head
inspected.
Set the spacing correctly
(Fig. 10).