Heatmor 400-4S, User Manual

Page: 64 / 95

59
Removal and Replacement of the Fan Power/Light Switch
1) Turn off the main electrical power supply to the HEATMOR™.
2) Remove the switch cover plate.
3) Make a sketch of the location of the wires on the switch.
4) Remove the wires, and replace the switch. This is a special 3-way switch.
5) Replace the wires as in the diagram.
6) Secure the cover plate.
7) Turn the main electrical power supply back on to the HEATMOR™.
Note: It is recommended to contact a licensed electrician to perform the above operation.
In the Event of a Power Failure
If a power failure occurs during the use of a HEATMOR™, do not open the firebox door to provide draft for
the fire to burn. Allow the fire to go out. In case of a prolonged power failure, a generator should be used as a
back-up power source.
Front Light