20
20356 Rev R
08-03
G136 SERIES INSTALLATION INSTRUCTIONS
Note:
Do not secure (screw) the upper pivot
bracket until the door is positioned.
WARNING!
Do not hit, strike, or slam shut the glass.
WARNING!
Do not operate this appliance if the glass is
broken or cracked.
13. Placing the Rock Wool
Break the rock wool into pieces, no bigger than 1/2
diameter and place them over the lava rock in the tray.
This will create the glowing ember appearance when
the flame touches the rock wool. Do not cover the
burner ports.
14. Glass Door Installation
d. Positioning the Doors
Place the upper pivot bracket on the top door pin
and insert the bottom pin of the door into bottom
pivot bracket. Attach the upper pivot bracket to
the door support using screws provided (two each
clip). See Figures 24 and 25. Close doors and raise
door support until door clip is caught under the
door support.
Install the second door in the same manner.
e. Leveling the Doors
Doors may be leveled by repositioning the pivot
brackets and pivot clips in the screw slots.
Loosen the screws, level the doors, then tighten
the screws. Do not over tighten the screws.
Figure 23
Close-up of Pivot Bracket
Figure 24
Positioning the Pivot Clips and Brackets
Figure 25
Installing the Glass Doors
Before beginning door installation procedures, remove
the clear, plastic protective covering that has been
placed on the upper and lower brass sections of each
door panel.
a. Installing Door Clip Covers
The door clip covers are not used if the gas
appliance uses the optional lower grille. To install
the door clip covers loosen the two screws located
at the bottom of the appliance opening on each of
the columns. Slide the recessed portion behind
the screw heads and secure the screws.
b. Attaching the Pivot Brackets
Attach the bottom pivot brackets (two each) to the
bottom edge of the opening of the gas appliance
(two screws each). See Figures 23 and 24.
c. Attaching the Top Door Support
Attach the door support at the top of the appliance
opening on each column using screws provided
(two each side). See Figure 24.
Note:
A fixed glass door (DF136B)
must be installed
for the appliance to be used in the Commonwealth of
Massachusetts. With a fixed glass door installed, there
is more than one square inch per 1000 BTU for
combustion air to enter the appliance.