08-03
20356 Rev R
23
G136 SERIES INSTALLATION INSTRUCTIONS
WARNING!
Children and adults should be alerted to the hazards of high surface temperatures and should stay away to
avoid burns or clothing ignition. Young children should be carefully supervised when they are in the same room
as the appliance.
CAUTION:
Clothing or other flammable material should not be
placed on or near the appliance.
4. Control Access Panel Removal
To remove the control access panel , gently lift upward
and tug on the outside top edges of the panel as
shown in Figure 27. The top of the panel will rotate
downward.
Two spring hinges secure the lower portion of the
control access panel into place. See Figures 28 and
29. Simply pull the hinges toward the center of the
panel and then pull out the entire control access
panel. To replace the panel, reverse this action.
If you own an electronic ignition appliance, at this point
skip Step 5 on the following page and continue with
Step 6 on page 25.
Figure 27 - Control Access Panel Removal
Figure 28 - Spring Hinges
Figure 29 - Control Access Panel Removal
Note:
When first operated, this appliance may re-
lease an odor for the first several hours. This is
caused by the curing of the paint and the burning off
of any oils remaining from manufacturing.
Before operating this appliance, please review
the safety precautions given on page 2 as well
as the items listed below:
1.
Check to make sure the logs, rock wool and lava
rock have all been placed correctly. Refer to Steps
11, 12 and 13 on pages 19 and 20.
2.
Check to see that all wiring is correct and enclosed
to prevent possible shock. This is done by opening
the control access panel (follow Step 4 below) to
access the control area.
3.
Check to ensure there are no gas leaks. This may
be done with a soap and water solution or gas
sniffer.
4.
Verify that all venting and caps are unobstructed.
5.
Read and understand these instructions thoroughly
before attempting to operate this appliance.
