Heatilator ECO-ADV-PS35, Owner'S Manual Installation And Operation, Page: 9 / 56

R R
9
Heatilator • ECO-ADV-PS35/50 • 7058-142D • July 21, 2010
F. Before Your First Fire
1. First, make sure your appliance has been properly
installed and that all safety requirements have been met.
Pay particular attention to the fire protection, venting and
thermostat installation instructions.
2. Double check that the ash drawer and firebox are
empty!
3. Close and latch the door.
NOTICE : The tip of the thermocouple must be in contact
with the inside end of the thermocouple cover or missed
ignitions can occur.
E. General Operating Information
1. Thermostat Calls For Heat
The appliance is like most modern furnaces; when the
thermostat calls for heat, your appliance will automatically
light and deliver heat.
When the room is up to temperature and the thermostat
is satisfied, the red call light will go off and the appliance
will shut down.
2. Heat Output Controls
This appliance is equipped with a heat output control
switch that has three settings or burn rates; low, medium
and high. Figure 9.1 .
The appliance will turn on and off as the thermostat
demands. When the thermostat calls for heat, the
appliance will start up at the burn rate for which it is set. If
the appliance is set at one of the lower settings, it will run
quieter but take longer to heat up an area than if it were
set at a higher burn rate.
Regardless of the burn rate, when the area is warm enough
to satisfy the thermostat, the appliance will shut off.
Figure 9.1
WARNING
Fire Hazard.
Keep combustible materials, gasoline
and other flammable vapors and liquids
clear of appliance.
• Do NOT store flammable materials in the appliance’s
vicinity.
• DO NOT USE GASOLINE, LANTERN FUEL, KEROSENE,
CHARCOAL LIGHTER FLUID OR SIMILAR LIQUIDS TO
START OR “FRESHEN UP” A FIRE IN THIS HEATER.
• DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS
SUCH AS GASOLINE, NAPHTHA OR ENGINE OIL.
• DO NOT USE CHEMICALS OF FLUIDS TO START THE
FIRE.
• Keep all such liquids well away from the heater while it is in
use.
• Combustible materials may ignite.
G. Hopper Lid Latch and Hopper Switch
1. Lift up the hopper lid and lock into open position. Now
you can fill the hopper with fuel.
2. The hopper switch is designed to shut down the feed
motor when the hopper lid is open.
Figure 9.2
.
3. To close the hopper lid, while holding lid open with one
hand, push the bottom of the latch inwards to release
from locked position and then slowly close the hopper
lid. Figure 9.3 .
Hopper Lid Latch
Hopper Switch
Push Bottom of Latch
Inward to Release
Figure 9.2
Figure 9.3