Heatilator • Caliber CD Series • 4040-263 Rev M • 06/08
10
I. Lighting Instructions (IPI)
• For normal use, activate/deactivate your
fi
replace with the wall switch or remote control.
• The IPI system may be operated with two D-cell batteries. When using batteries, unplug the transformer. To prolong
battery life, remove them when using the transformer.
• If
your
fi
replace must be deactivated for service or an extended period of time, follow the instructions below.
A.
This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by
hand.
B.
BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor
.
WHA
T T
O
DO IF YOU SMELL
GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in
your building.
•
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier
, call the fire
department.
LIGHTING INSTRUCTIONS
1.
ST
OP! Read the safety information above on this label.
2.
Tu
rn wall switch to the "OFF" position or thermostat to the
lowest setting.
3.
Tu
rn of
f all electric power to the appliance.
4.
This appliance is equipped with an ignition device which
automatically lights the pilot. Do NOT
try to light the pilot by
hand.
5.
W
ait five minutes to clear out any gas. If you then smell gas, ST
OP!
Follow "B" in the safety information above on this label. If you don't
smell gas, go to the next step.
6.
To
turn on the burner
, turn on all electric power to this appliance and
turn on the wall switch or set the thermostat to the desired setting.
7.
If the appliance will not operate, follow the instructions "T
O TURN OFF
GAS T
O APPLIANCE" and call your service technician or gas supplier
.
TO
TURN OFF GAS T
O
APPLIANCE
1.
Tu
rn of
f wall switch or set thermostat to lowest setting.
2.
Tu
rn of
f all electric power to the appliance if service is to be
performed.
3.
Push the gas control lever in and move to the "OFF" position
or push the gas control lever to the "OFF" position. Do not
force.
4.
Replace the control access panel.
Due to high surface temperatures, keep children, clothing and furniture away
.
Keep burner and control compartment clean. See installation and operating instructions accompanying
the appliance.
W
ARNING:
If you do not follow these instructions exactly
, a fire
or explosion may result causing property damage,
personal injury or loss of life.
FOR YOUR SAFETY
READ BEFORE LIGHTING
33631D
C.
Use only your hand to push in and move the gas control
valve or turn the gas control knob. Never use tools. If the
lever or knob will not move by hand, don't try to repair it, call
a qualified service technician. Force or attempted repair may
result in a fire or explosion.
D.
Do not use this appliance if any part has been under water
.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water
.
This appliance needs fresh air for safe operation
and must be installed so there are provisions for
adequate combustion and ventilation air
.
This appliance must be installed in accordance with
local codes, if any; if not, follow ANSI Z223.1 or
, in
Canada, current CAN/CGA-B149.
W
ARNING:
Improper installation,
adjustment, alteration, service or maintenance can
cause injury or property damage. Refer to the
owner's information manual provided with the
appliance. For assistance or additional information
consult a qualified installer
, service agency or the
gas supplier
.
CAUTION:
Hot while in operation. Do
not touch. Keep children, clothing, furniture,
gasoline and other liquids having flammable vapors
away
.
W
ARNING RISK OF FIRE
This appliance is intended to burn a specified gas
fuel only
. Do not attempt to use with solid wood fuel
or another type of fuel. Do not attempt to modify or
use any other type of gas burner system.
*
Also certified for installation in a bedroom or a
bed-sitting room.
*
For U.S. only!
W
ARNING:
Disconnect the electric power
before servicing. If for any reason the original wire
supplied with the appliance must be replaced, it must
be replaced with 105° C or its equivalent.
For use with natural gas or propane. A
conversion kit
as supplied by the manufacturer shall be used to
convert this appliance to the alternative fuel.
This appliance must be properly connected to a
venting system in accordance with the
manufacturer's installation instructions.
NA
TURAL
GAS
