5
Setup
Install the Notifi Elite Doorbell
Before connecting the Notifi Elite doorbell to a multi-tune electronic chime (see illustration on bottom of page 6), set the
chime to the desired tune. See chime manual for tune selection instructions.
NOTICE
NOTE:
The Notifi Elite doorbell requires a 16 volt AC, 10 watt or higher transformer.
1. Remove the existing wired push button.
2. Remove the backplate of the Notifi Elite doorbell by pushing in tab on the bottom with a small, flat-head screwdriver.
3. Insert the existing push button wires through the wire hole located just below the terminal screws. Attach the backplate to
the wall using the #6 screws (only use the screws included to ensure proper installation).
IMPORTANT:
Be careful not to bend the metal contacts during backplate installation or while connecting the wires to the
backplate.
4. Connect the wires to either screw terminal on the backplate.
5. Slide the top of the Notifi Elite doorbell down onto the backplate and press the bottom of the Elite doorbell against the
backplate until it snaps onto the backplate.
1
ATTACH BACKPLATE
CONNECT WIRES
Connect wires to screw terminals
REMOVE COVER
Push in tab with a small screwdriver
INSTALL COVER
Hook top of cover onto top of
backplate and rotate down until
cover snaps into place
IMPORTANT:
Be
careful not to bend the
metal contacts during
backplate installation
or while connecting the
wires to the backplate.
