Heat & Glo • MEZZO36-C/ST-C, MEZZO48-C/ST-C, MEZZO60-C/ST-C, MEZZO72-C/ST-C Installation Manual • 2600-980 Rev. D • 9/19
70
D. Install Glass Refractory Panels
CAUTION!
Risk of Cuts or Abrasions.
Wear protective
gloves and safety glasses during installation.
NOTICE:
Handle refractory panels with care. Refractory
may chip or crack if dropped or impacted.
B.
See-Through Models:
1.
Set left side glass panel, labeled B in Figure 1, into
firebox with the smooth side facing outward.
2. Bend the hand bend on the bracket down 90 degrees.
See Figure 4.
3. Install side glass brackets using one self-tapping
screw to secure the bracket to the firebox. See Figure
7.
4. Bend the tab on the glass bracket toward the side glass
panel until a 1/16 inch - 1/8 inch gap is created between
the tab and the side glass panel. See Figure 6.
5. Figure 7 shows retaining bracket installed. Repeat for
other side.
Glass Panel Instructions
See-Through Models: See Section B
A. Single-Sided Models
1. Set back glass panel, labeled A in Figure 1, into firebox
on top of the two back glass spacer blocks, with the
smooth side of the glass facing outward. Position the
retaining bracket inside appliance as shown in Figure
3. Line up the hole in the heat shield with the hole
closest to the bend in the bracket and secure in place
with a screw. See Figure 2 and Figure 3.
2. Bend the hand bend on the bracket down 90 degrees.
See Figure 4.
3. Install side glass brackets by pushing up on the corner
of the top heat shield and use two self-tapping screws
to secure the bracket to the firebox. See Figure 5.
4. Install the left side panel, labelled “B” in Figure 1, by
sliding it into place from the front. While installing,
press the panel firmly against the firebox side.
5. Bend the tab on the glass bracket toward the side glass
panel until a 1/16 inch - 1/8 inch gap is created between
the tab and the side glass panel. See Figure 6.
6. Repeat for other side.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
WARNING! Risk of Fire!
Remove all debris and objects
from firebox top and appliance top before operating the
appliance.
Inspect for and remove all debris that may have
accumulated or objects that may have been placed on
the firebox top and appliance top during the installation
process. All debris and objects must be removed prior to
operation of the appliance. Firebox top and appliance top
are shown in Figure 11.4.
Figure 11.4
APPLIANCE TOP
FIREBOX TOP
Optional Passive Heat Kit Installations Only: