65
Heat & Glo • COSMO32-IFT-B, COSMO36-IFT-B, COSMO42-IFT-B Installation Manual • 2619-980 Rev. G • 7/20
Figure 10.11 Maximum Finish Material Thickness - CFTF
Decorative Barrier Front
Inside Fit - CFTF Front
(1 Inch to 6 Inch Thick Finishing Material)
FINISHING MATERIAL
6 IN. MAXIMUM THICKNESS
FINISHING MATERIAL
6 IN. MAXIMUM THICKNESS
CFTF Decorative Front
Non-Combustible Finish Material 1-6 Inches Thick
1-3/16 IN.
1-3/16 IN. (CFTF)
1-3/16 IN.
Figure 10.12 Clearances to Appliance Opening With Outer
Decorative Barrier Front Trim
Figure 10.13 CFTF Front Installation With Outer Decorative
Barrier Front Trim
OUTER DECORATIVE
FRONT TRIM
INNER DECORATIVE
FRONT ASSEMBLY
TOP VANITY PANEL
(NOT SHOWN)
TABS (4)
FACE OF NON-COMBUSTIBLE BOARD
The CFTF is the only approved front for inside fit
applications (
fi
nish material over 1 inch thick). The CFTF
decorative barrier front can be installed with or without
the outer decorative barrier front trim (included with the
decorative barrier front). See Figure 10.11.
If the desired look is to include the outer decorative barrier
front trim,
fi
nishing materials up to 1-3/16 around the
fi
replace opening. See Figure 10.12. For this installation,
the inner decorative barrier front hangs on four tabs located
on outer decorative barrier front trim. The auxiliary hanging
brackets are not used and may be discarded. See Figure
10.13.
If the desired look is to exclude the outer decorative barrier
front trim,
fi
nishing material can be installed up to the
fi
replace opening. See Figure 10.14. For this installation,
the inner decorative barrier front hangs on four tabs located
on the auxiliary hanging brackets. The outer decorative
front trim is not used and may be discarded. See Figure
10.15.