Heat & Glo • COSMO32-IFT-B, COSMO36-IFT-B, COSMO42-IFT-B Installation Manual • 2619-980 Rev. G • 7/20
42
C. Securing and Leveling the Appliance
Figure 6.6 shows how to properly position and secure the
appliance. Nailing tabs are provided to secure the appli-
ance to the framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs
fl
ush with the framing.
• Level the appliance from side to side and front to back.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs. Use a minimum of one
fastener per nailing tab.
• Optional: Secure the appliance to the
fl
oor by inserting
two screws through the pilot holes at the bottom of the
appliance.
Risk of Fire!
Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible
materials
WARNING
DO NOT remove stando
ff
s or
notch the framing
around the appliance stando
ff
s.
Failure to maintain air space clearance could
cause overheating and
fi
re.
Block openings into the chase to prevent entry
of blown-in insulation. Make sure insulation and
other materials are secured.
Figure 6.6 Proper Positioning, Leveling And Securing Of Appliance
The COSMO32-IFT-B, COSMO36-IFT-B and COSMO42-
IFT-B models ship with factory-installed non-combustible
board. This board must be used. Do NOT remove. See
Figure 6.6.
NAILING TABS
BOTH SIDES
FACTORY-INSTALLED
NON-COMBUSTIBLE BOARD
DO NOT REMOVE