HCI BM15AP, Operation And Installation Manual

Page: 10 / 27

Installa
tion
Re-
move
Remove the safety screw and the lock plate from teh BedMate Stem
Install the Bedmate onto the arm, make sure
the groove in the stem is tight in the lock
screw.
Install this TV only on an arm that has been properly mounted according to the arm and
mount
manufacturer’s instructions. Make sure the arm is locked into its retracted position. If the arm
cannot be
locked into its retracted position, raise the outer arm to its highest position to install the TV.
Failure to
Remove the side panels from the
nose of the arm. There are two
screws holding each side panel in
place.
Connect the coax cable from the TV to the coax cable from the
arm using the supplies coupler. Slightly wrench tighten both
coax connectors to the coupler just enough that you can not
undo the connection by hand.
DO NOT OVER TIGHTEN. 1/16 TO 1/8 TURN PAST FINGER TIGHT
IS ENOUGH.
Make the network (optional) connection. Gently tuck wires in-
side arm, and close cover. Plug in power supply and proceed to
TV setup.
Install the lock plate on the stem. Make sure the
plate is tight over the lock screw, and tighten down
the safety screw.
Installa
tion