HBM SCOUT55, Operating Manual

Page: 41 / 64

41
Scout 55
HBM A0236-5.9 en
DEC. POINT
Changes the position of the decimal point.
Selectable positions
.0000 0.000 00.00 000.0 0000
For above example a: .00
for above example b: .000
STEP
You can choose the step or the digit step.
Selectable steps 1 2 5 10 20 50 100 200 500 1000
ZERO VALUE
The maximum zero balance range matches the particular maximum
measuring range in the following table.
RANGE:
Sets a full scale value (unit mV/V). If this value lies outside the input range,
the minimum or maximum possible value is accepted.
Input range Range at UB = 2.5V Range at UB = 1V
I " 0.2...4 mV/V " 0.5...10 mV/V
II " 2...40 mV/V " 5...100 mV/V
III " 20...400 mV/V " 50...1000 mV/V
TARE VALUE:
You can specify a tare value (in display units) (net value = gross value minus
tare value).
3.5.6 Limit values 1...4 (LIMITVAL.1...4)
The parameters for setting the limit values are combined in a group for each
limit value. The status of the limit switches is shown on the display and carried
out over the control outputs.
The function of the limit switches and their parameters are shown in the
following diagram:
Switching on
switching level
Hysteresis value
switching level
Switching on
Switching off
Switching off
Over limit
Below limit
Hysteresis value
24V
0V
24V
0V
Gr1
Gr2
LV1 ACTIVE.HIGH
LV2 ACTIVE.HIGH
Fig. 3.2:
Limit value functions and parameters