HBM SCOUT55, Operating Manual

Page: 13 / 64

13
Scout 55
HBM A0236-5.9 en
2.2.1 Setting the analogue output signal
Select the analogue output signal (voltage or current) by replugging jumpers
ST11 (see Fig. 2.1). Choose between " 20 mA or 4...20 mA in the control
dialogue.
2.2.2 Choosing the operating mode for synchronisation
To synchronise several devices, set one device as the Master. All the other
devices should then set to Slave. The “Master” and “Slave” selections are
made with jumpers ST13, ST14 and ST15 (see Fig. 2.1).
2.3 Connecting the voltage supply
Check that the mains voltage of the device (details on the back of the device)
matches the supply voltage. If this is not the case, change the device setup as
described under 2.3.1 .
synchro-
nisation
analogue
output
5 outputs/
6 inputs
interface port
transducer
connection
(15-pin
female
connector)
mains connection
Fig. 2.2:
Back of the device
An inlet connector for non-heating devices is provided for connecting the
mains cable. The requisite mains power supply cable is included in the list of
components supplied.
Country-specific versions are available as accessories.