Manifold Filter
Cleaning the In-Line Filters
1.
The Hose In-Line filter (Part Q) is located by the Wall
Quick Connect (Part K).
2.
To remove the screen inside the In-Line Filter, unscrew
the cap of the In-Line Filter and remove the screen.
3.
Remove the debris from the screen and rinse.
Important:
If the screen frequently becomes plugged,
the filtration system is not performing properly or
there is another plumbing problem.
4.
Place the open end of the screen into the outlet end of
the In-Line Filter and screw the cap back on.
Important:
Make sure the O-Ring is in place and properly seated.
Caution - Risk of Equipment Damage
Never operate the cleaner without the screen in place.
Operating the cleaner without the screen will damage
the cleaner’s internal mechanism.
5.
Inlet Manifold filter screen stays in manifold inlet
when hose is removed for storage.
6.
If there is debris in the filter it can be removed for cleaning
by grasping the bar and gently pulling while twisting.
7.
Rinse to ensure that all debris and sand is removed
from the inlet filter screen.
8.
Before replacing the manifold, check that there is
no debris visible inside of manifold inlet. If sand or
debris can be seen, gently rinse out manifold using a
water hose with inlet pointed down.
14
Use Only Genuine Hayward Replacement Parts.
Maintenance
Removing the Viio Cleaner From The Pool
Warning – Risk of Injury
The Filtration Pump and Booster Pump must be OFF
when connecting or disconnecting cleaner or hose.
1. Turn the Booster Pump and Filtration Pump OFF.
If you will not be replacing the cleaner before the
next Booster Pump timer cycle, turn the Booster
Pump Timer
OFF. Never
run the Booster Pump
without the cleaner connected.
Failure to do so can
cause serious injury.
Caution - Risk of Equipment Damage. Never
run the Booster Pump without the Cleaner
connected. Doing so will damage the pump’s motor
and void the Booster Pump’s warranty.
2.
From the pool deck looking down push the Wall
Quick Connect into the Universal Wall Fitting and
turn it to the right (clockwise).
3.
Pull the Wall Quick Connect out of the Universal
Wall Fitting.
4.
Remove the cleaner from the pool.
5.
Disconnect the Cleaner Connector from the Viio
cleaner.
6.
Lay the Pressure Hose and Sweep Hose flat and
straight.
Important:
Always store the Pressure Hose and
Sweep Hose straight,
not coiled.
The cleaner may
not operate properly with bent hoses.
Emptying the Debris Bag
Empty the Debris Bag regularly. Do not continue to
operate the Viio when the bag is full.
Sand (dense debris): Always empty the Viio bag when
sand (or heavy debris) fills the bag up to the blue
“Empty Sand Line”.
DO NOT operate Viio if it runs on its side.
1.
Hold Bag over trash can or wherever debris is to
be placed.
2.
Slide Float Closure off of bag
3.
Hold open edges apart and shake debris from bag.
4.
Slide Float Closure onto bag.
In-Line Filter
In-Line Filter
Screen
