Important Safety Instructions
1
Use Only Genuine Hayward Replacement Parts.
Warning
Read this entire Owner’s Guide before installing the
Viio cleaner. Failure to follow safety warnings and
owner’s guide instructions can result in severe injury,
death or property damage.
Warning – Risk of Electrical Shock
The Hayward Viio Turbo Automatic Pool Cleaner is
designed to connect to a threaded 1-1/2 inch female
pipe fitting on a dedicated return line that is powered by
a 3/4 H.P. Booster Pump.
All electrical connections
must be done by a qualified electrician according to
local electrical standard. If the supply cord is
damaged, it must be replacing by the manufacturer,
its service agent or similarly qualified persons in
order to avoid a hazard.
Warning – Risk of Injury
Failure to follow the safety warnings below may result
in severe injury, death or property damage
.
• Always disconnect and remove the cleaner and
pressure hose before entering the pool.
• Always handle with care. Do not let children or pets
play with the cleaner; it is not a toy.
• Always turn the Booster Pump
OFF
before handling
cleaner
• Do not operate outside the pool. The Viio Turbo
Cleaner and hoses contain high-pressure water jets
that may cause injury.
• Disconnect pressure hose from the universal wall
fitting before removing the cleaner from the pool.
•
Never
point any of the cleaner’s high-pressure jets,
pressure hose or sweep hose at any person or pets.
Important Information
Caution – Risk of Equipment Damage
• Always turn the Filtration Pump on before turning the
booster pump on. Running the booster pump dry will
damage the booster pump and is not covered by the
Hayward warranty.
• Always disconnect and remove the Viio cleaner and
hoses from the pool before cleaning or backwashing
the pool filter.
• After cleaning or backwashing the pool filter, allow the
filtration system to run for a minimum of five minutes
or until all debris has been flushed from plumbing lines
before reconnecting the Viio cleaner.
• New plumbing lines must be flushed out before
connecting the Viio cleaner.
• The Viio cleaner should not be used to remove plaster
dust or construction debris from new or renovated
pools.
• The Viio cleaner should not be used to remove
excessive sand (dense debris) following wind or
sandstorm.
• Always disconnect and remove the Viio cleaner and
hoses before chemically shocking the pool.
• Only operate the Viio cleaner for the period of time
necessary to clean the pool. Excessive use is
unnecessary and will cause cleaner parts to
prematurely wear.
• Regularly inspect the cleaner and hoses; do not use if
damaged or if any rough edges are visible on the
cleaner; this can cause damage to the pool.
• Only pick-up the Viio cleaner by its wing (Part A, page
4), never by the hose or bag.
Disclaimer
• Pool plaster is affected by age, water chemistry, etc.
• Pool plaster can deteriorate over a period of time.
• The integrity of “good” pool plaster is such that a pool
vacuum cleaner – automatic or manual – cannot
remove the plaster.
• The integrity of “good” pool plaster is such that the
plaster will cause wear on the cleaner, the cleaner will
not wear out “good” pool plaster.
• Vinyl pool liners are affected by age, sunlight, and
water chemistry.
• Vinyl pool liners can become brittle and weak.
• Vinyl pool liners can be affected by the installation and
the pool's surroundings.
• Patterns on vinyl pool liners vary in quality.
• When installing the Viio cleaner, you assume
responsibility for the condition of the pool and the
pool's surroundings and chemistry.
