7
Use Only Genuine Hayward Replacement Parts.
Assembling and
Sizing the Rigid Pressure Hose
Assembling and Sizing the Rigid Pressure Hose
1.
Open the plastic bag labeled #1 that contains 10
Rigid Hose Pipes (Part N) and 5 Hose Pipe
Couplings (Part I).
2.
Lubricate the 5 Hose Pipe Couplings by dunking
them in soapy water.
3.
Align the Barbs on the Hose Pipe Coupling with the
Tabs on the Rigid Hose Pipes and snap together. Be
sure the black o-ring does not slip out of the groove on
the Hose Pipe Coupling (if the o-ring is visible through
the latch opening when pipes are snapped together the
o-ring has slipped out of the groove and will leak)
4.
Make 5
Sets
of
Pipe Assemblies
by connecting 1
Rigid Hose Pipe onto each end of the Hose Pipe
Couplings.
5.
Locate the “Measuring Tape” (packed in Bag #1),
secure the end of the tape marked “Wall Connector
End” on the pool coping immediately above the
Universal Wall Fitting.
6.
Unroll the Measuring Tape, walk around the pool to
the farthest point along the pool wall from the
Universal Wall Fitting.
At the farthest point from the Universal Wall Fitting
holdthe Measuring Tape at the pool edge/coping
and read the number of Pipe Assemblies specified
on the tape.
Rigid Hose Pipe Assembly
Measuring Tape
Connecting Hose Pipes
I
N
a.
Note:
If the measuring tape specifies more than 5
Pipe Assemblies, you need to purchase the
additional Pipe sections (P/N AEX6000HE) from
your Authorized Hayward Dealer.
b. If the measuring tape specifies fewer than 5 Pipe
Assemblies, set the remaining Pipe Assemblies
aside these will not be needed.
Rectangular-Shaped Pool
Kidney-Shaped Pool
Angle-Shaped Pool
Universal Wall
Fitting
(Dedicated Line)
Universal Wall
Fitting
(Dedicated Line)
Farthest Point
Farthest Point
Universal Wall
Fitting
(Dedicated Line)
Farthest Point
I
N
1 Pipe
Assembly
