Hawkeye Mfg AGCO RoGator A Series, Installation Manual

Page: 48 / 54

A
PPENDIX
A
44 Hawkeye® 2 Installation Manual for AGCO RoGator A/B-Series (RG900, RG1100, RG1300)
FIGURE 2. Upper Panel Right of the Operator Seat
4. Disconnect the ISO terminator from the 3-pin connector.
5. Plug in the ISOBUS adapter cable to the connectors to allow the ROS device to interface with the machine
ISOBUS and the Raven Hawkeye® 2 nozzle control system.
6. Plug the ISO terminator plug on to the second connector on the cable.
7. Route the adapter cable to the back of the ROS device and connect to the receptacle labeled “5.”
8. To prevent issues with the Hawkeye® 2 Icon showing up on the C1000, perform the steps in AGCO Service
Bulletin Number 16-0104. This bulleting provides the steps to set the ISOBUS Terminal Generation to UT 2, turn
the ISOBUS Terminal Functions On, and assign the terminal number.
NOTE: If step 8 does not resolve any issues, contact an AGCO technician for assistance with updating the
C1000 software to the latest version.