Form No. SRCEM-0314
8
iNStALLAtiON
General
Serv-Rite
®
SRBW-1, SRGBW-1, and SRSSBW-1 models are
shipped with most components pre-assembled. The glass
sneeze guard must be installed on location. Serv-Rite SRB-1,
SRG-1, and SRSS-1 models are shipped fully assembled and
ready for use. Care should be taken when unpacking the
shipping carton to avoid damage to the unit and components
enclosed.
eLeCtRiC ShOCk hAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 21°C (70°F).
FiRe hAzARD: Locate unit a minimum of 25 mm (1″) from
combustible walls and materials. if safe distances are not
maintained, combustion or discoloration could occur.
1. Remove the unit from the carton.
2. Remove tape and protective packaging from all surfaces
of unit.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTaNT OWNER INFORMaTION
section for
details.
3. For SRBW-1, SRGBW-1, and SRSSBW-1 models, install
the glass sneeze guard. The glass sneeze guard is
installed between two plastic caps at each support post for
protection.
Do not attempt to install glass sneeze guard alone.
installation of glass sneeze guard is a two-person job.
a. Place a plastic cap with the flat side facing up on each
of the support posts.
b. Carefully place the glass sneeze guard on top of the
support posts and plastic caps. Make sure the holes in
the glass sneeze guard are aligned with the holes in the
plastic caps.
c. Place a plastic cap with the flat side facing down over
each of the holes on the glass sneeze guard. Make sure
to align the holes in the plastic caps with the holes in the
glass sneeze guard.
d. Insert the cap screws through the top plastic caps, the
glass sneeze guard, the bottom plastic caps, and into
the support posts.
e. Tighten each cap screw until secure.
NOtiCe: Do not
over-tighten the cap screws.
NOTICE
WARNING
Glass Sneeze Guard Installation
Do not move unit by lifting or pulling it by the sneeze guard.
4. Place the unit in the desired location.
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
Cap Screw
Top Plastic
Cap
Bottom
Plastic
Cap
Support
Post
Glass
Sneeze
Guard
NOTICE
Summary of Contents for SeRv-Rite SRB Series
Page 86: ...Form No SRCEM 0314 86 NOteS ...
Page 87: ...Form No SRCEM 0314 87 NOteS ...
